The easiest way to hang a tapestry without nails: slide a thin wooden dowel through the top hem, or clip the tapestry to it, and rest the dowel on two adhesive hooks. Use hooks rated for at least twice the tapestry’s weight. The dowel keeps the top edge straight, spreads the weight across both hooks and comes down without marks.
Weigh Your Tapestry First
Every no-nail method depends on weight. Stand on a bathroom scale, note the number, then step on again holding the folded tapestry and the dowel. The difference is what your hooks must hold. DG Floors recommends adhesive hooks rated for at least 2 times the total weight, so a 3-pound tapestry and dowel needs hooks rated for 6 pounds combined.
Printed polyester tapestries usually weigh little. Woven tapestries weigh more and need the stronger methods below.
Method 1: Adhesive Hooks and a Dowel
- Buy a wooden dowel 2 to 4 inches longer than the tapestry width, and two adhesive hooks with enough weight rating.
- Clean the wall where the hooks go with rubbing alcohol and let it dry.
- Mark the hook spots with a pencil and a level. Space them so each sits 2 to 3 inches in from the ends of the tapestry.
- Press each hook on for 30 seconds, then wait the time listed on the package before you load it.
- Slide the dowel through the rod pocket or clip the tapestry to it, then rest the dowel on the hooks.
Interior designers at Havenly suggest the same setup and point out that clear adhesive hooks almost disappear behind the dowel.
Method 2: Tension Rod in an Alcove
If the tapestry hangs in an alcove, a doorway or between two cabinets, a spring tension rod needs no hooks at all. Twist the rod until it presses firmly against both side walls, then hang the tapestry from it with clips or through the rod pocket. This works for narrow spaces up to the length of the rod.
Method 3: Wooden Poster Hanger
A magnetic or clamp-style wooden hanger grips the top and bottom edges of the tapestry and hangs from a single cord. One strong adhesive hook in the center holds it. This suits smaller tapestries, around 26 by 36 inches, and gives a finished, framed look with weight along the bottom so the fabric hangs flat.
Method 4: Clips on a Lightweight Rod
Curtain clip rings let you hang a tapestry with no rod pocket and no holes in the fabric. Decoist recommends clips or curtain rings along the top edge, hung from a rod or hooks. Space the clips 8 to 10 inches apart so the top edge doesn’t sag between them.
Method 5: Velcro Strips
Heavy-duty Velcro strips hold a light tapestry flat against the wall with nothing showing. They suit tapestries without a hem or pocket. Test first: DG Floors reports that industrial Velcro removes cleanly from properly painted drywall but leaves residue on flat and matte paint.
If You Can Use Nails or Pins
Small nails or push pins at the corners work, but check the weave first. Bob Vila notes that a tight weave may get holes from nails or pushpins, while a thin weave lets them through without damage. For a woven or heavier tapestry, put two small nails in the wall and rest a rod on them instead of pinning the fabric.
Get It Straight and Flat
- Hang the top edge first and check it with a level before you add any clips or pins below.
- Let the tapestry hang for a day. Most fold lines drop out on their own.
- Steam stubborn creases on the lowest setting the care label allows, holding the steamer an inch from the fabric.
- If the bottom edge curls, slide a second thin dowel into the bottom hem or clip one on behind it.
Where Not to Hang It
Keep tapestries out of direct sunlight. Bob Vila warns that sun fades the dyes. Avoid the wall right above a radiator or in a steamy bathroom, where heat and damp can warp the dowel and leave the fabric limp.
Still choosing a size? Our tapestry size guide has charts for every bed and couch, and our wall tapestries collection is where new designs land.
Want more wall art ideas, room styling tips and first access to new Bruzzen collections? Join the list — free.
Subscribe Free →
